70561 Door Buffer-See P11/23 $9.00

These little buffers are seemingly everywhere. I think someone at the factory got a good deal on a whole pallet load and ran around an Interceptor stating 'one will go here and one here; yep, one here and two over there! Your doors take three, 2 on...

S260 Grommet, Accelerator See P11/14 $1.50

These little rubber grommets really get around!  We use 2 of these on either side of the lever & shaft clamp block of the accelerator pedal rod instead of the original bearings.  If I don't make sense check out page K3 item 14 of your...

CT832 Bush, Pedal Lever-S260 GROMMET P11/14 $1.50

We use these little guys for the pedal bush and in that hole your bonnet prop rod fits into on the bonnet and down below the rod somewhere---.  Buy three for your pedal and one or two for the bonnet prop rod.

71438 Bonnet Lock Striker-Used $0.00

Please email or call. Thanks.

70199 Bracket Stay Support $15.00

Bracket Bonnet Stay Support

Spring Washer, Bonnet Hinge Plate $8.00

This washer has large raised ridges to help grab the clamping plates or washers fitted onto to the threaded portion of the bonnet hinge pin. This plate/washer is accessed through that small hole that you have to get your hand into to spin onto the...

CT950 Drain Tube Valve $35.00

Kind of as the name applies, these are the little bulbous valves at the end of the drain tubes, in the cowl and the boot.

70205 Bonnet Stay Rod $39.95

Here we have the Bonnet 'stay' rod.  Anyway, this is the metal stick attached to the inside of your engine bay and you put it in the bracket hole attached to the bonnet itself. Don't forget the grommets for your holes!